Accessories; Removing The Chuck; Tips And Tricks; Environmental Protection - Metabo BE 622 S- R+L Mode D'emploi

8.3 Tool change with a geared chuck (1)
3x
Chucking the tool: Insert the tool and use the
chuck key to uniformly clamp tight all 3 bores.
Removing the tool: Open the geared chuck with
the chuck key and remove the tool.
8.4

Removing the chuck

Geared chuck (1)
Undo the locking screw. THIS SCREW HAS A
LEFT-HANDED THREAD!
Hold the drill spindle tight with a spanner. With a
light blow from a rubber hammer, release the
chuck from the inserted chuck key and unscrew it.

9 Tips and Tricks

In the case of deep bores pull the drill bit out of the
bore from time to time in order to remove the bore
dust or shavings.
The chuck can be removed for screwdriving. Insert
screwdriver bit directly in the hexagon socket of
the spindle.
When the bit spring collet is fitted, the screwdriver
bit is held in position.
10 Trouble Shooting
If the trigger (4) can not be depressed, check to
see that the direction of rotation selector switch (3)
is fully set to the R or L position.

11 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Angle Drilling and Screwdriving Attachment
B Flexible Shaft
C Drill Stand
D Moulding & Drill Stand
E Machine Vice
F Steel-wire End Brush
G Steel-wire Cup Brush
H Steel-wire Wheel Brush
I Fitting bit spring
For complete range of accessories, see
www.metabo.com or the main catalogue.
12 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.

13 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline
ENGLISH
ENG
11