Separett Tiny 1271 Manuel D'installation page 6

Installation without visible urine hose
For installation without visible pipes, the 90-degree bend is used to guide the urine downwards or the
straight joint to go backwards as shown in the pictures below. Use the enclosed installation template to
make holes in the wall or floor in the correct positions.
Installation with visible urine hose
In cases where installation without visible pipes is not possible, a 90 degree bend is used to install the urine
hose to the side (right or left) according to the pictures below.
If the urine hose is to be laid sideways and the toilet is to be installed against the wall, the urine hose must be
led through the side of the toilet, which requires a hole to be made in the plastic. For optimal results, use the
same drill you would use for making holes in the wall. The toilet has marks on either side to show where the
hole should be made, see pictures below. If you find it difficult to drill from the inside, use a smaller drill to make
a small hole in the center, and then continue to drill from the outside. Use a knife or sandpaper to get a good
border.
If the urine hose is to be led further within the room, use the supplied Wall mount for urine hose.
Make sure that the urine hose has a downward inclination all the way and that you have read through the
recommendations for installing the urine hose.
10
Installation of pipe cap or ventilation cowl
It is important to ensure that the end of the ventilation pipe is protected from rain and snow, and prevents
insects from entering the toilet. To achieve this, the toilet comes with a pipe cap that is equipped with an
integrated insect net. This pipe cap should be used when the pipe end is horizontal and must be mounted
with the screen upwards to ensure protection from rain and snow. The pipe cap fits both 50 mm and 1.5
inch pipes. 50 mm pipes go half way in and 1.5 inch pipes go all the way in. See picture below.
The pipe cap can be fixed to the pipe through the visible screw markings.
When the pipe end is vertical, the supplied ventilation cowl is to be used together with a pipe cap to ensure
that rain and snow do not enter the pipe.
Pipe cap and ventilation cowl are mounted together with the two supplied screws as shown below.
11