Publicité
Les langues disponibles
Les langues disponibles
Use Side Impact Protection
see images
-
1
2
1. The enhanced child restraint is delivered with removable side impact
protection pod. Insert the side impact pod on the side closest to the
door. Installation shown in
2. Press the release button to remove side impact protection pod.
Height Adjustment
for Head Support and Shoulder Harnesses
see images
-
3
6
Please adjust the head support and check if the shoulder harnesses
are at the correct height according to
!
When used in harness mode, the shoulder harness height
must be even with or just above the top of child's shoulders.
!
When used in booster mode, the shoulder belt guides must be even
with child's shoulders.
4
Press the head support adjustment lever
the head support until it clicks into one of the 12 positions, shown as
.
6
Recline Adjustment
see images
-
7
8
Press the recline adjustment button to adjust the seat angle to the
desired position, shown as
There are 3 recline positions that can be used for both harness mode
and booster mode.
8
7
.
1
&
&
&
3
4
5
6
and pull up or push down
5
7
&
8
.
Child Restraint Installation
see images
1. Insert ISOFIX guides to assist with installation.
2. Press the ISOFIX adjuster button to extend the ISOFIX.
3. Make sure that both ISOFIX connectors are securely attached to
2
their ISOFIX anchor points. The colors of the indicators on both
ISOFIX connectors should be completely green.
!
Press the ISOFIX adjustment buttons again while pushing the seat
back until it comes in contact with the vehicle seat backrest.
Removing the seat
1. To remove from the vehicle press the ISOFIX adjuster button and pull
the base back from the seat. Then press and release the connectors
from the vehicle's ISOFIX.
2. To prevent damage during transit, press the ISOFIX adjuster button
3
-1
and fold the connector completely.
13
Use top tether
1. To extend top tether for use, press the button on tether adjuster and
pull to lengthen.
2. Connect the tether hook securely to vehicle's anchorage point. (see
vehicle owner's manual).
!
Make sure that tether hook is securely attached to the anchorage
point. Tension the tether strap until the indicator shows green
completely.
!
When not in use, top tether must be properly stored. To make sure
the top tether is properly stored away, remove any slack in strap to
avoid the top tether swinging around when the vehicle is in
progress.
17
!
Make sure the top tether's indicator is in green after the seat recline
angle is adjusted; if not, tighten the tether strap again until it turns
green completely.
-
9
17
12
13
14
15
16
9
-1&
-2
10
10
-1
11
-2
8
Publicité
