Astralpool LUMIPLUS PAR56 RGB 1.11 WIRELESS Manuel D'installation Et D'entretien page 5

The numbers of the sequences appear on the display numbered from 1 to 8.
SEQUENCE
Estival Red Green
Caroline
Cyan Magenta
Iris
Green Esmerald green
Candy Red Orange
Tropical
Red
Paradise Red Orange
Abril Pale violet Magenta
Eleven
Red Green
- Refresh button
In pools with more than one lamp, this button is used to synchronise them.
If one of the lamps fails to respond to the COLOR/SEQUENCE commands, press the REFRESH button on the lamp and
the last command will be sent so that it synchronises with the others.
- Selecting the speed of sequences
The -/+ buttons enable you to select one of the eight sequences, ordered from the slowest to the fastest speed.
- Switching spotlights off
The spotlights are turned off by pressing the ON/OFF button. The status (colour/sequence) of the lamps is stored in the
memory for the next time the system is switched on.
- Switching the remote control off
The remote control automatically switches off in less than 60 seconds.
The LED display lights on the remote control only light up for a few seconds.
7.2 Control motion mode (see page 28)
When the control motion mode is switched on, the colours and sequences can be changed.
Changing the colour (Fig. A)
- Hold the remote control firmly without touching any of the buttons.
- Flick your wrist downwards.
- The change in colour will be displayed on the Central Display.
Changing the sequence (Fig. B)
- Hold the remote control firmly without touching any of the buttons.
- Flick you wrist form side to side.
- The change in sequence will be displayed on the Central Display.
8. CONTROL MOTION MAINTENANCE:
If the Central Display lights up in red without switching off, this means the batteries are low. The battery case is on the
back of the Control Motion unit; replace the old batteries with two new AAA 1.5 V ones.
9. WIRING
Diagram of the wiring (see page 28)
In order to wire the system properly, a lamp, transformer and the Control Motion unit will be needed.
The transformer should be connected to a 230 V~ac power supply and the lamp (12 V~ac) to the auxiliary winding.
It must be sized to supply the corresponding VA to each LED lamp that is wired (see table on the back cover). For
example, if you wish to control two 37 W PAR56 1.11 lamps they must be wired in parallel to the transformer to at
least 74 VA.
Alternatively, the system can be controlled using a simple NC push button, in which case there will be 14 function
modes: seven set colours and seven different colour sequences. Each time the push button is pressed, the colour or
sequence will change. By pressing for several seconds, the light becomes white.
Blue
Yellow
Cyan Sky-blue
Green Orange
Pink Blue Pink
Green Cyan
Cyan Yellow
Blue Yellow
ORDER OF COLOURS
Blue Pink
White Yellow Cyan
Cyan Magenta Pale
violet
5
Magenta
Sky-blue Orange Pink Esmerald White
green