Problemas Y Soluciones; Safety Warnings - Astralpool LUMIPLUS PAR56 RGB 1.11 WIRELESS Manuel D'installation Et D'entretien

10. PROBLEMAS Y SOLUCIONES:

PROBLEMS
The lamp or spotlight is not working
The lamp projects a different colour
to that shown on the Control Motion
Central Display
Two lamps project different colours
Using the control motion mode, the
lamp or spotlight does not work
Control Motion is not responding

11. SAFETY WARNINGS:

• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIM-
MING POOLS
• All maintenance operations should be performed with the lamp disconnected from the Mains.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric compo-
nents which have been inserted or handled at locations other than its own premises.
• The PAR56 lamp of LEDs withstands to the treatments of swimming pool described next as long as the values of
concentration do not surpass the following values:
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
The lamp or spotlight does not have a
power supply
The lamp/s or spotlight/s do not receive
information
The Control Motion batteries are low
TYPE OF TREATMENT
USUAL CAUSES
CONCENTRATION IN WATER
6
SOLUTIONS
Connect the lamp or spotlight to the
power supply through a 12 V~ac
safety transformer.
1. Get close to the lamp or spotlight
before sending a command
2. Do not cover the antenna with
your hand
3. Press the REFRESH button
Change the batteries
2 g/l
5 g/l
6 g/l