Wolf Garten Campus 32 E Notice D'instruction D'origine page 11

Connection to the plug socket (230 Volt, 50 Hz)
z Only connect the mower to plug sockets having a 16 Amp.
fuse (slow acting) (or LS Switch Type B).
3
Note: Residual current protection device
These protection devices protect against serious injury
when touching damaged wires, insulation faults and in cer-
tain cases also when damaging wires under potential.
z We recommend that the mower only be connected to
plug sockets which are protected by a residual current
protection device (RCD) having a residual current of no
more than 30 mA.
z There are retro-fitting sets for older installations. Consult
your specialist electrician.
Switching the mower on/off
z Switch the mower on when standing on level ground.
z Not in long grass– or tilt if necessary
Motor on K
1. Push button (1) and hold it down.
2. Pull the bracket (2).
3. Release the button (1).
Maintenance
General
1
Caution! Rotating cutters
Before all maintenance and cleaning tasks:
z Pull the mains plug out.
z Take care not to grab running cutters.
Cleaning
z Always clean the lawnmower after each use with a handbrush.
Simply stand it vertically on the collection basket.
z Never spray the mower with water.
Storage
z At the end of each mowing season, you should perform a
complete cleaning operation on the mower.
z The mower should be checked by a WOLF-Garten customer
service workshop in the autumn.
z Store the mower in a dry room.
G
All manuals and user guides at all-guides.com
Motor off
z Release the bracket (2).
Tips for mowing
z In order to prevent stripes on the lawn, always overlap the
z Always lay the cable securely on the terrace, paths or grass
Emptying of Grassbox
The grassbox is full and should be emptied as soon as grass clip-
pings remain uncollected on the ground behind your mower.
1
L
.
Changing the cutters
z When performing any work on the cutters, coupling and cutter
1
z Always have the cutters changed by a specialist workshop. A
z Use only original WOLF-Garten spare parts.
K
tracks of the cut by a few centimetres
which has already been cut.
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Empty collection bag.
z Remove potential blockages in the cutting space before
starting.
N
beam, pull the plug out and wear protective gloves.
Caution!
After the cutters have been sharpened there could be imba-
lance.
z Always have the cutters sharpened by a specialist work-
shop, since a balance test in accordance with the safety
regulations must be carried out.
19 mm torque wrench is an absolute must.
Torque for tightening the bolts: 13 - 19 Nm
M
.
N
.
11