Checking The Battery Charge Level - Parkside PAP 20 A1 Mode D'emploi

CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
broken.
■ Never recharge a battery pack again immediately
after rapid charging. This could overcharge the
battery pack, thus reducing the lifespan of the
battery and charger.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains power
socket.

Checking the battery charge level

♦ Press the battery charge level button
the status of the battery (see also main diagram).
The status/remaining charge will be shown on the
battery display LED
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PAP 20 A1
flashes, this means
has overheated and
as follows:
GB│IE │
both
is
to check
29 ■