Make sure that the wall is strong
enough to withstand at least 8 times
the weight of the device and the
mount.
Make sure that the power has been
disconnected before you wire, install,
or disassemble the device.
Transportation
Keep the device in original or similar
packaging while transporting it.
Do not drop the product or subject it
to physical shock.
Power Supply
The power source should meet
limited power source or PS2
requirements according to IEC
60950-1 or IEC 62368-1 standard.
Refer to the device label for the
standard power supply. Please make
sure your power supply matches
with your device.
Use a power adapter provided by
qualified manufacturers. It is
recommended to provide an
independent power adapter for each
device as adapter overload may
cause over-heating or a fire hazard.
System Security
Please understand that you have the
responsibility to configure all the
passwords and other security
settings about the device, and keep
your user name and password.
Maintenance
If the product does not work
properly, please contact your dealer
or the nearest service center. We
shall not assume any responsibility
for problems caused by unauthorized
repair or maintenance.
A few device components (e.g.,
electrolytic capacitor) require regular
replacement. The average lifespan
varies, so periodic checking is
recommended. Contact your dealer
for details.
Cleaning
Please use a soft and dry cloth to
clean the interior and exterior
surfaces. Do not use alkaline
detergents.
Using Environment
When any laser equipment is in use,
make sure that the device lens is not
exposed to the laser beam, or it may
burn out.
Do not aim the lens at the sun or any
other bright light.
To avoid heat accumulation, good
ventilation is required for a proper
operating environment.
DO NOT expose the device to
extremely hot, cold, dusty, corrosive,
saline-alkali, or damp environments.
For temperature and humidity
requirements, see device
specification.
DO NOT expose the device to high
electromagnetic radiation.
Illuminator
Make sure that there is no reflective
surface too close to the device lens.
The light from the device may reflect
back into the lens causing reflection.
The beam of the light at the distance
of 200 mm is classified as Risk Group
1 (RG1). Possible hazardous optical
radiation emitted from this product.
DO NOT stare at operating light
source. May be harmful to the eyes.
If appropriate shielding or eye
protection is not available, turn on
the light only at a safe distance or in
the area that is not directly exposed
to the light when installing or
maintaining the device.
Emergency
If smoke, odor, or noise arises from
the device, immediately turn off the
power, unplug the power cable, and
contact the service center.
Time Synchronization
Set up device time manually for the
first time access if the local time is
15