Triangle ELARA Série Mode D'emploi page 29

Connection via an RCA cable
line
The RCA input enables you to connect your Elara active speakers to your TV, CD player, turntable
or any other device. To do so:
Î Plug the red and white connectors into "RCA INPUT" on the back of the speaker, minding the
colours, and do the same on the source.
Î Select the "RCA" input using the remote or the "INPUT" button (volume button) on the back of
the active speaker. (Source selecting order is indicated above the "INPUT" button.) The green
LED indicates that the source is actually connected to the "RCA" input. Make sure the selector is
switched to "LINE". Your system is ready to operate.
Connecting a turntable:
To plug a vinyl player, push the "PHONO IN" switch to the left for the signal to pass through
the phono chain. Connect the ground wire to the dedicated screw terminal on the back of your
amplified speaker and to your turntable.
Connection via a 1/8-inch (3.5mm) jack cable
The jack input - for a 3.5mm jack cable - (AUX IN) enables you to connect your speakers to many
devices: smartphone, audio player, tablet, computer, television, etc. To do so:
Î Plug one end of the jack connector into the "AUX INPUT" terminal and the opposite end into
your device.
Î Select the "3.5" input using the remote or the "INPUT" button (volume button) on the back of
the amplified speaker. (The source selecting order is indicated above the "INPUT" button.) The
green LED indicates that the source is actually connected to the "AUX" input. Your system is
ready to operate.
or
27
phono
EN