NOE Kranbock Notice D'utilisation page 21

Formwork elements must not be transported with loose parts lying on them.
6.
Loads must be taken up and set down in such a way that they cannot accidentally
7.
tilt over, collapse, slide off or roll off.
The ropes and chains used must not be tensioned across sharp edges on loads.
8.
Steel wire cables and round steel chains must not be knotted.
9.
Twisted chains must be straightened out before being used to raise a load.
10.
Loads must not be set down on the NOE lifting dog owing to the risk of damage.
11.
The NOE lifting dog must be protected against weathering and corrosive
12.
substances, as these may impair its safety and operational reliability.
Persons using the NOE lifting dog must keep an eye open for signs of any obvious
13.
defects, such as deformation, cracking, breaks or missing markings.
It is the contractor's responsibility to ensure that an NOE lilting dog with defects
14.
that may put safety at risk is taken out of circulation.
It is the contractor's responsibility to ensure that any necessary repairs to the NOE
15.
lifting dog are made exclusively by the manufacturer.
It is the contractor's responsibility to ensure that the NOE lifting dog is only used
16.
after it has been inspected and approved by an expert and not until any defects
detected have been rectified.
It is the contractor's responsibility to ensure that the NOE lifting dog is inspected by
17.
an expert at intervals of no more than one year, and that the checking procedure is
confirmed by means of a inspection stamp.
It is the contractor's responsibility to ensure that the NOE lifting dog is submitted to
18.
an expert for special inspection following damage or specific events which may
affect its load capacity, as well as after repairs.
Stand: 07/2019 21