Silverline HO0001 009 Mode D'emploi page 26

ASSEMBLY OF PRODUCT
Assembly of Rear Outlet
10.2 Assembly of Rear Outlet
Fig. 21: Removing the bolts of the
motor
Fig. 22: Mount the air exit canal on
the rear wall
26
The motor can be rotated 90° inside the hood, so the air exit canal
can be installed directly through the wall towards rear. To do this,
proceed as follows.
1. Remove the bolts of the motor (Fig. 21).
2. Press out the perforated plate on the back wall of the hood
(Fig. 22/1).
3. Screw the motor back to the rear wall.
ð The motor is located on the rear wall.
4. Screw the pressed out perforated plate to the previous air
exit hole with the 2 bolts (Fig. 22/2).
Contact your authorized service or customer
service for the subjects that you want to get infor-
mation (Fig. 22).
ENGLISH 06.03.2023