Selecting The Operating Mode; Volume/Bass; Charging External Devices - SilverCrest SCUR 3 A1 Mode D'emploi Et Consignes De Sécurité

Selecting the operating mode

♦ While the device is switched on, press the
desired mode is shown on the display
–
"Cd" for CD playback
–
"FM" and the frequency for radio playback
–
"AUX" for playback from an external device connected to the AUX IN
input

Volume/bass

♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
or to the left to decrease the volume. The set volume will be shown on the
display
♦ Press the XBASS button
activated, "XBASS" is shown on the display
NOTE
► In AUX mode you can also set the volume on the external device if this is
connected to the CD clock radio via the AUX IN input
► Reduce the volume on the external device if the playback sounds distorted.

Charging external devices

The CD clock radio has a charging function which you can use to charge the bat-
teries of devices that are usually charged via a USB connection. The maximum
charging current is 1.0 A.
NOTE
► The USB connection
► The CD clock radio must be connected to the mains in order to charge
external devices.
► You can purchase a suitable USB charging cable (not supplied) in any
consumer electronics shop.
♦ Insert the USB-A connector on the USB charging cable into the USB connec-
tion
♦ Insert the other USB connector on the USB charging cable into the USB
connection on the external device.
♦ The external device will start charging after a few seconds. During this, the
CD clock radio can be switched on or in standby mode.
♦ After charging the external device, pull the USB charging cable out of the
USB connection
SCUR 3 A1
as a value between "L00" (mute) and "L25" (maximum volume).
button to turn up the bass. If this function is
is exclusively for charging external devices.
on the CD clock radio.
to disconnect
/SOURCE button
:
to the right to increase the volume
.
.
the devices from each other.
GB │ IE
until the
41 ■
│