Publicité
Les langues disponibles
Les langues disponibles
Important Safety Instructions
FCC RADIATION EXPOSURE STATEMENT:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated so
there is at least 8 inches (20 cm) between the radiator and your body. This device
and its antenna(s) must not be co-located or operated in conjunction with any
other antenna or transmitter.
2. IC Notice
The term "IC" before the radio certification number only signifies that Industry
Canada technical specifications were met. Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation
of the device.
This Class B digital apparatus complies with Canadian ICES-003. For products sold
in the US and Canadian markets, only channels 1-11 are available. You cannot
select any other channels.
IC RADIATION EXPOSURE STATEMENT:
This equipment complies with the IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and operated
so there is at least 8 inches (20 cm) between the radiator and your body. This
device and its antenna(s) must not be co-located or operated in conjunction with
any other antenna or transmitter.
4 English
DG68-01416C-02_IB(FULL)_NK30CB600W12AA.indb 4
DG68-01416C-02_IB(FULL)_NK30CB600W12AA.indb 4
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING PRECAUTIONS:
• Use this unit only in the manner intended by the manufacturer. If you have
questions, contact the manufacturer.
• Before servicing or cleaning the unit, switch the power off at the service panel and
lock the service panel to prevent the power from being switched on accidentally.
If the service panel cannot be locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
• The installation work and electrical wiring must be done by qualified person(s)
in accordance with all applicable codes and standards, including fire-rated
construction.
• Sufficient air is needed for proper combustion and the exhausting of gases
through the flue (chimney) of the fuel burning equipment to prevent backdrafting.
Follow the heating equipment manufacturer's guidelines and safety standards,
such as those published by the National Fire Protection Association (NFPA), the
American Society for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
• When cutting or drilling into the wall or ceiling, do not damage electrical wiring or
other hidden utilities.
• Ducted fans must always be vented outdoors.
CAUTION
For general ventilating use only. Do not use to exhaust hazardous or explosive
materials and vapors.
CAUTION
To reduce the risk of fire and to properly exhaust air, be sure to duct air outside -
do not vent exhaust air into spaces enclosed within walls, ceilings, attics, or into
crawl spaces or garages.
2023-05-30 오전 10:54:21
2023-05-30 오전 10:54:21
Publicité
