Festo DSMI−25−B Notice D'utilisation page 34

DSMI−...−B
· Connect the measuring system to the connecting cable
as described in the description of the positioning controller.
The PIN assignment is shown in the table below:
Pin Designation
1 DC +10 V
2 Signal
3 GND
4 Screen
1) )
Terminating resistor: 5 k Terminating resistor: 5 k
Linearity: ±0.25 %
Fig. 20
For interrogation of the end positions
with DSMI−12 ... 40−B:
· Place the proximity switch (B)
SME/SMT−10F−...−KL on the groove
of the shock absorber retainer.
A sensor bracket (D è Accessories) is
required to fasten the proximity switch.
The proximity switch is actuated by
magnets (C) in the stop lever.
For interrogation of the end positions
with DSMI−63 ...−B:
· Place the SME/SMT−8..−... proximity
sensor (B) in the sensor bracket
(E è Accessories).
The proximity sensor is actuated by
magnets (C) in the stop lever.
34
1)
Assignment
3 3
2
(D) (B)
Fig. 21
(B) (E)
Fig. 22
Festo DSMI−...−B 1003a English
1 1
4
(C)
(C)