Festo DSMI−25−B Notice D'utilisation page 30

DSMI−...−B
1. Remove the cover cap of the DSMI from the housing (if present).
2. Swivel the moving mass to the desired
end position.
If the DSMI is depressurised, this can be
done by hand or using a hexagon spanner
on the swivel lever aA.
The angle scale can be used for precise
positioning.
DSMI−...−B
Graduation (1 graduation mark =)
Fig. 10
3. Unscrew the locking screws aB for the
shock absorber retainers. To shift the
shock absorber retainers, it is sufficient to
slacken the locking screws until they can
just barely be shifted.
4. Push the shock absorber retainer towards
the stop lever until the adjustment sleeve
or the fixed stop of the shock absorber
(elastomer shock absorber or shock
absorber) touches the stop lever.
5. Retighten the locking screw aB of the
shock absorber retainer with the following
tightening torque.
Only with the specified tightening torque
will the gearing of the shock absorber
retainer grip the housing material.
DSMI−...−B
Tightening torque aB
Fig. 14
30
Fig. 9
25
[°]
2
Fig. 11
Fig. 12
aB
Fig. 13
25
[Nm]
10
Festo DSMI−...−B 1003a English
40 63
1
1
40 63
79
39