Texas Equipment RMX 500 Manuel D'utilisation page 80

Cleaning the underside
Use work gloves just in case! At least every
month it will be necessary to clean the robotic
lawn mower on the underside and especially at
the blades.
Remember to start by turning off the robot. Place
the robot on its side on a soft surface (e.g., the
lawn) so as not to scratch it.
Use a soft brush or a plastic scraper to clean
grass to ensure a good mowing result. Regular
cleaning also reduces cutting noise and
vibration.
4. Check that the knife holder can rotate freely.
5. Check that the blades can rotate freely.
6. Check that the front wheel can rotate and rotate freely.
Important! Regular cleaning is essential for the robot to work as it should!
Be sure to follow the above cleaning advice - and do it often. Grass settles easily
anywhere and can affect sensors and functionality. Especially before winter storage!
Problems caused by lack of cleaning are not covered by the warranty.
Cleaning of charging station.
Just as the robot must be cleaned often, it is a good idea to clean the charging station at
the same time. Remove grass and soil on the running plate. Cut down grass growing
around the charging station. Use a simple grass shear.
Approximately, every 2 months the charging contacts at the charging station and on the
robot should be inspected and possibly cleaned. Use some fine sanding paper or steel
wool to remove any rust or iring on the charging connectors.
Cutting blades
The blades have two sharp sides. Therefore, they can be turned over when they have
become blurry on one side. It is recommended to replace all the blades and screws (at the
same time) after each season to ensure a good cutting result. (keep an eye on the blades
and replace more often if needed). The cutting blades can be easily changed. Use a
Phillips screwdriver (turn off the robot before working with the blades). Unscrew the screw,
remove dirt and grass debris on the blade disc. Replace the blades with new ones and at
the same time replace the screws. Use the included extra blades and screws. Make sure
the blade screws are tightened well. Use gloves to protect the hands.
Note: All 3 blades must be turned or changed at the same time to avoid imbalance.
80