Texas Equipment RMX 500 Manuel D'utilisation page 78

In addition, it is also important that the charging station is set up at least 10 meters from
the neighbor's boundary wire.
If your neighbor has a robot lawn mower from another manufacturer, it may be necessary
to keep a distance to the neighbor's boundary cable of 2 meters to avoid interference.
19. Rain sensor
The robot has a rain sensor built in. If it registers water, the robot will stop working and
return back to the charging station and wait 3 hours. The rain sensor settings can be
adjusted inside the App. See Section 17 "App Use."
20. Handling the robot lawn mower
Removing cover
The upper cover can be removed if necessary. Follow this procedure:
1. Press down on the robot's height adjustment button (keep hold it down)
2. Grap the underside of the upper deck in one of the rear corners and pull up until you
can feel it release its grip.
3. Then grab the opposite back corner and pull it up so that it released.
4. Repeat with both of the front corners (one at a time)
5. Once the upper cover is free in all corners, it can be removed (there are no cables
attached to it)
Attach cover
1. Put the cover on top of the robot lawn mower. Look through the hole above the display
and make sure that the holes in both back corners match the 2 sticks on the robot.
2. Press the cover firmly on the 2 sticks (one at a time) by pressing on the cover just
above the sticks.
3. Repeat over the 2 sticks in the front of the robot (one at a time)
Push/hold
Lift/pull
78