Texas Equipment RMX 500 Manuel D'utilisation page 79

Transport and moving the robot
1. Use the carrying handle under the rear end to carry the robot with. Never lift it at the
edge of the cover, as the upper cover may risk detach, resulting in dropping the robot
to the ground.
2. It is recommended to transport the robot lawn mower in the original packaging if it is
over longer distances. It is also good to have it for winter storage of the robot.
3. When the robot needs to be moved away from the cutting area or to change settings
via the display, the big red STOP button must be activated (see picture).
4. When the STOP button is activated, the robot must be turned off. Hold down the OFF
button until the display turns off.
21. Cleaning and replacement of parts
It is important to keep your robot lawn mower clean to extend its life.
The robot will be able to handle
slopes more easily if the wheels are
clean and in order. Likewise, the
cutting result becomes better when
the blades are sharp and can turn
around freely (always turn off the
robot completely before touching
the blades).
Cleaning the plastic cover
Do not rinse robot with a water hose
or pressure washer to protect the
electronics and battery in the robot
lawn mower.
It is recommended to use a soft
brush to remove grass and other dirt.
Possibly a water atomizer or damp
cloth to dissolve dirt.
Grass can also get stucked around the 4 sensor sticks under the upper cover.
Remove the upper cover (see Section 20 "Handling the robot lawn mower") and remove all
grass with a soft brush. Move the 4 sensor sticks with your hand to make sure they are ok.
79