Texas Equipment RMX 500 Manuel D'utilisation page 73

Schedule
Under schedule you can see scheduled cutting times and set when the robot should work.
• Tap "Edit"
to edit the schedule.
• Tap the day of the week you'd like to set the robot to run.
• Then select the start time and end time and press "Confirm".
• Edge cutting: In the top line "edge" (under "Edit") you can put a blue check mark if you
want the robot to edge cut the first time it starts. The robot will then follow the boundary
wire all the way around and cut along it (note that the robot will still leave an uncut
edge with grass, as the knife cannot cut all the way to the edge for safety reasons).
If you start the robot manually via START + OK on the display, the robot will not edge
cut. To avoid wheel tracks, it is recommended to choose" edge" only a few days a
week.
• When a schedule is defined (orange) you can also change the start/end time by
pressing "Edit" and holding your finger on the orange area and letting your finger swipe
up or down.
• Press "Save"
Home screen
If you have a large lawn area, the robot has to work more often than if the lawn is smaller.
If your lawn is close to the robot's max capacity (m
day for extended periods daily. The layout of the lawn also has an impact on how much
the robot needs to work to keep the grass down. A single square lawn without obstacles is
faster to mow rather than a lawn with narrow passages and many obstacles, since the
robot here has to spend more time stopping and changing direction.
It is recommended to try it out different time settings and see the result. The robot should
not work more than necessary to avoid driving tracks on the lawn.
During the growing season and when it rains quite a bit, the robot needs to work more
often. During dry periods, it should work less.
It is also recommended, as far as possible, to let the robot run in when the grass is dry.
In some periods, the grass is damp at the beginning of the day and at the end of the day.
Afternoon is typically the best time.
when the schedule is completed.
Schedule overview Set edge clipping
2
), it will probably have to work every
73
Set time