Bosch 0 607 561 114 Mode D'emploi page 20

Saw Blade Recommendations
The jigsaw is delivered with different saw blades.
Choose the saw blade that is appropriate for your
work from the following table.
q specially suitable for
❍ suitable for
Solid wood
Particle board
Plastic-coated /
laminated wood fiberboard
Bonded wood /
wood composite materials
PVC, general plastics
Metals
Sheet metal
Note: Only T-shank type blades (Single Lug Shank) fit
in this jigsaw.
Do not remove the safety cover!
14 The safety cover 14 attached to the
housing prevents accidental contact
with the saw blade 11 during opera-
tion.
11
Installing the Saw Blade
Disconnect the air hose from the air supply be-
fore making any adjustments, changing acces-
sories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool acciden-
tally.
The Bosch SDS system provides a
simple and convenient way to change
saw blades without any tools.
When removing a saw blade, avoid contact with
skin and use proper protective gloves when
grasping the blade or accessory. Saw blades and
accessories may become hot during prolonged use.
To install the saw blade, set the orbit
selector switch 9 to setting III. This
position provides the easiest insertion
access for the saw blade.
9
3 609 929 250 • (04.07) T
All manuals and user guides at all-guides.com
4 MOUNTING
q q
❍ q
❍
–
❍
–
q
–
– –
– –
–
Push the orange-colored SDS blade change button 1
downward. This unlocks the barrel grip 2.
–
Turn the barrel grip 2 approximately three turns coun-
–
terclockwise.
13
–
–
q
q
Insert the saw blade 11 into the opening of the plunger
13 perpendicular to the cutting direction. There are
two small grooves in the blade plunger into which the
"T-tabs" on the blade fit precisely. Turn the saw blade
11 90° in the cutting direction and push it into the
groove of the roller guide 12. The saw teeth should
now point towards the front of the saw. Pull the saw
blade 11 slightly downward.
Turn the barrel grip 2 clockwise until you hear the lock-
ing mechanism engage or "click" a few times. Pull the
orange-colored SDS blade change button 1 back up.
This locks the barrel grip in place.
Check that the saw blades are seated firmly in
the tool before you connect the tool to the air
supply. Saw blades that are not clamped properly in
the appropriate holder may slip out and can cause
damage to the workpiece or injury to you or others.
English–6
1
2
11
12
1
2