xFUME™ ADVANCED HP 230V – CSA
6.2 Mounting the current clamp
A current clamp is supplied with the device. A second current clamp is optionally available for the
connection of a second fume extraction torch.
6.3 Attaching the compressed air hose
Fig. 3 Control elements/ports on page EN-10
Screw in the compressed air connection including sealing ring.
1
Mount the compressed air hose on the compressed air connection (B) and connect to the compressed
2
air supply.
6 Commissioning
Connect the current clamp cable to the current
1
clamp port.
Lay the current clamp over the cable assembly
2
and ensure that the red point on the current clamp
always points in the direction of the current flow.
Set the <Auto/Manual> switch to <Auto>.
3
EN - 13