Abicor Binzel xFUME ADVANCED HP 230V-CSA Mode D'emploi page 10

4 Product description
4.2 Control elements and connections
Fig. 3
A Service LED
B Operation LED
C Power LED
D Hour meter
E <Auto/Manual> switch
F <On/Off> switch
<Auto/Manual> switch (E) The automatic starting function is activated when the switch is set to
Service LED (A)
Operation LED (B)
Power LED (C)
EN - 10
Control elements/ports
A B
K J
<Auto>. If the switch is set to <Manual>, the automatic starting function is
inactive and the device must be switched on and off manually.
The device is equipped with a safety device to monitor the minimum air
volume flow to be extracted. A differential pressure switch is used for
monitoring purposes. The service LED illuminates in continuously when
both filter cartridges are not functioning properly or are saturated and
must be replaced. During initialization, the service LED and the power
LED flash alternately.
The operation LED illuminates continuously when the motor is running.
During initialization, the power LED and the service LED flash alternately.
The power LED illuminates continuously if the device has been switched
on by the <On/Off> switch.
xFUME™ ADVANCED HP 230V – CSA
G Mains connecting cable
H Speed controller
I Fuse
J Current clamp port 1
K Current clamp port 2
C D
I H G
E F