Connection Between Cooktop And Control Unit - bora PIW 1 Instructions De Montage Et De Service

Installation
Afterwards, attach
mounting brackets.
► For
hygiene reasons,
appliances overleaf with temperature-resistant
silicone/sealant. Please observe that also the
section between the devices must be seamed
(1). Remove excess sealant to ensure a clean
seam pattern (2).
The BORA logo must be positioned in the rear right
corner of the built-in cooktops.
Connection between cooktop and control
unit
Finally the connection between the hob and the
control unit must be established. To do so, first
connect the yellow-green earthing connection with
the buckle mechanism marked with q and then
connect the two 8-pole plugs of the hob colour-
correct to the corresponding socket parts of the
control unit.
30
the appliances with
seam the build-in
the
g