Télécharger Imprimer la page

Inventum HZ31 Mode D'emploi page 14

Masquer les pouces Voir aussi pour HZ31:

Publicité

Les langues disponibles

Les langues disponibles

NOTE
• The fastest way to heat up the foot warmer is to select the highest temperature setting of the controller, first.
NOTE
• This foot warmer has a fast heating function, which allows the foot warmer to warm up faster in the first
10 minutes.
WARNING
If the foot warmer is used continuously (for several hours) it is
reccomended to use the lowest setting (1) of the control to avoid
overheating of the feet of the user, which may lead to burns to the
skin.
4.5 Automatic switch off
This foot warmer is equipped with an automatic switch-off function. This turns off the heat supply approx. 90
minutes after the initial use of the foot warmer. The temperature setting display then starts to flash. So that the foot
warmer can be switched back on, the sliding switch for ON/OFF and temperature setting must first be set to setting 0
(OFF). After about 5 seconds it is possible to switch it on again.
4.6 Switching off
To switch off the foot warmer, set the slider for ON/OFF and temperature settings to setting 0 (OFF). The temperature settings are
then no longer illuminated.
NOTE
If the foot warmer is not in use, switch the sliding switch for ON/OFF and temperature settings to setting 0 (OFF) and unplug
the mains plug from the socket.
5
cleaning & maintenance
WARNING
Before cleaning, always remove the mains plug from the socket first. Otherwise there is a risk of electric shock.
CAUTION
• The controller must never get in contact to water or other liquids. Otherwise, the controller may be damaged.
To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
Small marks on the foot warmer can be removed with a damp cloth or sponge, or if necessary, with a little liquid detergent for delicate
laundry.
CAUTION
• Please note that the foot warmer may not be washed, chemically cleaned, wrung out, tumble dried, put through a mangle or
ironed. Failure to do so may damage the foot warmer.
The removable fleece lining can be washed by hand.
Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
WARNING
• Only use the foot warmer again once the foot warmer and fleece insert have fully dried. Otherwise there is a risk of electric
shock.
14
English
All manuals and user guides at all-guides.com

Publicité

loading