LiftMaster ELITE Serie Mode D'emploi page 17
Système d'ouverture de porte de garage pour usage résidentiel et commercial léger. installer en les portes de sectionnelle avec ensembles de torsion seulement
Masquer les pouces
Voir aussi pour ELITE Serie:
- Manuel d'installation (108 pages) ,
- Mode d'emploi (82 pages) ,
- Manuel du propriétaire (80 pages)
Publicité
Les langues disponibles
Les langues disponibles
Installation
MOUNTING AND WIRING THE SAFETY REVERSING SENSORS
1
Slide a 1/4"-20x1/2" carriage bolt head into the slot on each sensor.
Use wing nuts to fasten safety reversing sensors to brackets, with lenses pointing
2
toward each other across the door. Be sure the lens is not obstructed by a bracket
extension.
3
Finger tighten the wing nuts.
Wing Nut
4
Run the wires from both safety reversing sensors to the opener. Use insulated staples
to secure wire to wall and ceiling.
Strip 7/16" (11 mm) of insulation from each set of wires. Separate white and white/
5
black wires suffi ciently to connect to the opener quick-connect terminals: white to
white and white/black to grey.
7/16
(11 mm)
WHITE/
BLACK
WHITE
Carriage Bolt
Bell wire
17
HARDWARE
Carriage Bolt
1/4"-20x1/2"
Wing Nut
1/4"-20
HARDWARE
Staple
Publicité
