Publicité
Les langues disponibles
Les langues disponibles
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Put on necessary personal protective equipment.
Personal protective equipment on page 6 .
Refer to
3. Make sure that only approved persons are in the
work area.
4. Do daily maintenance. Refer to
schedule on page 16 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
on page 19 .
7. Make sure that there are diamond tools on the tool
plates and the diamond tools and the tool plates are
tightly attached.
8. Connect a dust extractor to the product. Refer to
connect a dust extractor on page 11 .
9. Adjust the handle and the handlebar to an applicable
operation height. Refer to
the handlebar on page 12 .
10. Make sure that the motor cable is connected to the
electrical enclosure before the product is connected
to a mains outlet. Refer to
grinding head on page 17 .
11. Connect the product to a power source. Refer to
connect the product to a power source on page 12 .
12. Turn the emergency stop button on the control panel
clockwise to make sure that the emergency stop
button is disengaged.
13. Make sure that you know the direction of rotation of
the grinding discs when you use direction diamond
tools such as Piranhas.
Diamond tools
There are many different types and configurations of
diamond tools for the product. Metal bonded diamond
tools are used for removal of material and resin bonded
diamond tools are used to polish surfaces. Select the
correct diamond tools for the surface. Speak to your
Husqvarna dealer or go to www.husqvarnacp.com for
support to select the correct tool.
1211 - 004 - 09.12.2022
Maintenance
Transportation
To
To adjust the handle and
To install and remove the
To
Disc holder alternatives for diamond tools
•
Use a Redi lock disc holder to attach metal bonded
diamond tools.
•
Use a resin disc holder to attach plastic bonded
diamond tools.
Full set and half set of diamond tools
The configuration of the diamond tool segments has
an effect on the end quality of the surface. The
configuration also has an effect on the operation rate
of the product.
•
Full set of diamond tools: This configuration is
applicable for a flat floor finish.
•
Half set of diamond tools: This configuration is
applicable when a flat floor finish is not necessary.
To replace the diamond tools
WARNING:
power plug before you replace the diamond
tools, to prevent accidental start.
WARNING:
diamond tools can become very hot.
WARNING:
protection when you replace the diamond
Always disconnect the
Use protective gloves, as
Use approved respiratory
9
Publicité
