Husqvarna PG 540 Manuel D'utilisation page 14

2. Turn the STOP/RUN switch (A) on the control panel
counterclockwise to 0 to make sure that the grinding
head is off.
3. Turn the ON/OFF switch (B) on the control panel
to 1 to start the product. The LED adjacent to the
ON/OFF switch comes on.
4. Turn the STOP/RUN switch on the control panel
clockwise to start the grinding head. In less than 5
seconds, the product operates at idle speed.
To stop the product
CAUTION:
from the surface when you stop the motor.
The tool plates rotate for a while after the
motor stops. Dust can go into the air and the
surface can become damaged.
CAUTION:
become stationary until the tool plates stop
fully.
1. Turn the STOP/RUN switch (A) on the control panel
counterclockwise to 0 to stop the grinding head.
2. Keep the tool plates against the surface until they
stop fully.
CAUTION:
asphalt, paint or equivalent material,
the product can attach to the adhesive
surface. Immediately after the tool plate
stopped fully, lift up the front of the
grinding head a small distance.
3. Turn the ON/OFF switch (B) on the control panel
to 0 to stop the product. The LED adjacent to the
ON/OFF switch goes off.
14
B
A
Do not lift the grinding head
Do not let the product
B
A
If you grind adhesive
4. Disconnect the power plug.
To reset the product
The ON/OFF switch can be used as a reset switch if the
inverter releases. Reset the product when the indicator
inverter to the grinding motor (A) is red.
A
1. Turn the STOP/RUN switch (B) counterclockwise to
0 to make sure that the grinding head is off.
2. Turn the ON/OFF switch to the arrow position (C) to
reset the product. The indicator for the inverter to the
grinding motor is green when the fault is reset.
3. Turn the STOP/RUN switch on the control panel
clockwise to start the grinding head again.
Weights
The product has 1 weight on each side of the product.
If the product is heavy to operate, adjust the weights to
change the pressure on the grinding head. The weights
must be adjusted to the same position on the right and
the left side. The weights has 2 positions:
• Position 1: Maximum pressure on the grinding head.
This position increases the operation effect. This
position is also used when you set the product in
transport position.
B C
1211 - 004 - 09.12.2022