Husqvarna PG 540 Manuel D'utilisation page 11

11. Attach the tool plate straight (E) on the grinding disc.
12. Turn the tool plate (F) to the right or to the left to lock
the tool plate to the grinding disc.
13. Carefully lift the product with the handlebar to
operation position.
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Make sure that the STOP/RUN switch on the control
panel is set to 0.
4. Connect the dust extractor hose to the product.
1211 - 004 - 09.12.2022
E
F
Do not use the dust
5. Hang the dust extractor hose on the suspension
device at the door to electrical box to prevent tension
in the dust extractor hose.
Handle positions
• Operation position of the handle:
• Transport position of the handle:
11