Publicité
Les langues disponibles
Les langues disponibles
BM 1619X03886 07-09:BM 1619X03886 07-09 7/23/09 10:54 AM Page 13
If an extension cord is
W RNING
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
Read instruction manual first! Always lock trigger in the center "OFF" position
W RNING
before making adjustments or assembling accessories.
TROUBLE: TOOL WILL NOT START
PROBLEM
1. Battery not charged.
2. Battery temperature is too hot or cold for operation.
3. Burned out switch.
REMEDy
1. If equipped, check battery charge condition lights for charge status.
Charge battery if needed.
2. Let battery sit a few minutes or until it reaches normal operating
temperature.
3. Have switch replaced by an Authorized Skil Service Center or Service Station.
TROUBLE: BATTERy WILL NOT CHARGE
PROBLEM
1. Charger not plugged into outlet.
2. Charger's connector pin not completely inserted into tool.
REMEDy
1. Confirm charger is plugged into outlet.
2. Confirm charger's connector pin is completely inserted into tool.
All manuals and user guides at all-guides.com
Accessories
Trouble Shooting
-13-
RECOMMENDED SIZES OF ExTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25
50
100 150
3-6
18
16
16
14
6-8
18
16
14
12
8-10
18
16
14
12
10-12
16
16
14
12
12-16
14
12
—
—
2
Wire Sizes in mm
Cord Length in Meters
15
30
60
120
0.75 0.75 1.5
2.5
0.75 1.0 2.5
4.0
0.75 1.0 2.5
4.0
1.0 2.5 4.0
—
—
—
—
—
Publicité
