Kärcher K 6.75 Jubilee Mode D'emploi page 17

Description of the Appliance
Illustrations on Page 4
1 Water connection
2 Fine filter in the water connection
3 Coupling element for water connection
4 Quick coupling for high pressure hose
5 High pressure connection
6 Appliance switch "0/OFF"/ „I/ON"
7 Detergent Tank
8 Dosage regulator for detergent
9 Storage for trigger gun
10 Detergent suction hose (with filter)
11 Transport handle
12 Storage for high-pressure hose
13 Storage for accessories
14 Mains cable with mains plug
15 Bearing wheel
16 Lock trigger gun
17 Trigger gun
18 Key to detach the high-pressure hose
from the trigger gun
19 High pressure hose
20 Spray lance with Dirtblaster
21 Spray lance with pressure regulation
(Vario Power)
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.
Before Startup
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on fold-out
pages!
Illustration
î Insert the transport handle and screw
in.
î Insert holder for trigger gun.
Illustration
î Connect the suction hose for detergent
to the dosage regulator.
Illustration
î Lock the dosage regulator for detergent
into the cover.
Illustration
î Insert the cover and screw in.
Illustration
î Pull the suction hose for detergent
through the cover of the detergent tank
until the filter contacts teh bottom of the
tank.
Illustration
î Close the detergent tank with the lid.
î Lock the detergent tank in place on the
appliance.
Illustration
î Attach the accessories holder.
Illustration
î Fasten the quick coupling for the high
pressure hose to the high pressure con-
nection.
Water supply
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
î Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
î Screw the coupling element (supplied)
to the water connection on the appli-
ance.
î Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
– 8