Publicité
Les langues disponibles
Les langues disponibles
tached water supply (max. 1 minute)
and wait, until no more water exits at the
high-pressure connection. Turn off the
appliance.
î Store the appliance and the entire ac-
cessories in a frost-safe room.
Maintenance and care
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Prior to longer periods of storage, e.g. in
the winter:
î Remove filter from suction hose for de-
tergent and clean under running water.
î Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
î Pull out the fine filter in water connec-
tion using flat-nose pliers and clean with
running water.
Maintenance
The appliance is maintenance-free.
Spare parts
Use only original KÄRCHER spare parts.
You will find a list of spare parts at the end
of these operating instructions.
Troubleshooting
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
Appliance is not running
î Pull on the lever of the trigger gun; the
device will switch on.
Care
î Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
î Check the mains connection cable for
damages.
Pressure does not build up in the
appliance
î Check setting at the spray lance.
î Appliance ventilation: Switch the appli-
ance on with the high-pressure hose
detached and operate (max. 2 minutes)
until the water exits the high-pressure
connection without bubbles. Switch off
appliance and reconnect high-pressure
hose.
î Check the water supply.
î Pull out the fine filter in water connec-
tion using flat-nose pliers and clean with
running water.
Appliance does not start, motor hums
Cause: Voltage reduction due to weak
mains supply or when using an extension
cable.
î When switching on, first pull the lever of
the trigger gun and then switch the ap-
pliance switch to "I/ON".
Strong pressure fluctuations
î Clean high-pressure nozzle: Remove
dirt and debris from the nozzle bore, us-
ing a needle and rinse through with wa-
ter from the front.
î Check water flow quantity.
Appliance is leaking
î Slight leakage from the appliance pump
is normal. If the leakage increases con-
tact the authorized customer service.
No detergent infeed
î Use spray lance with pressure regula-
tion (Vario Power).
Turn the spray lance to "Mix" position.
î Detach spray lance from the trigger
gun. Work only with the trigger gun.
î Clean the detergent suction hose filter.
î Check the detergent suction hose for
kinks.
î Check the settings at the dosage regu-
lator for detergent.
– 11
Publicité
