Publicité
Les langues disponibles
Les langues disponibles
USE
Step 6
•
Place the radial seal carrier with the front side on the
installation tool.
•
Make sure that the guide pin B is inserted into the hole
on the control ring A.
•
Note: Make sure that the radial sealing ring carrier lies
completely on the installation tool.
Step 7
•
Press radial seal carrier and support ring for sealing lip C
against the surface of the installation tool.
•
Tighten the three knurled screws D so that the guide pin
remains in the bore of the control ring.
•
Note: When installing the radial seal carrier, make sure
that the control ring remains fixed in the installation tool.
Step 8
•
The crankshaft flange must be free of oil and grease.
•
Check that the engine is still at TDC.
•
Screw large hexagon nut B to the end of the threaded
spindle.
•
Press the threaded spindle of the installation tool in the
direction of the arrow until the large hexagon nut B
touches the housing of the installation tool A.
•
Align the flat edge of the installation tool with the oil pan-
side sealing surface of the crankcase and push the new
radial seal carrier over the crankshaft and onto the
cylinder block.
•
Insert guide pin E into the hole in the crankshaft. This will
ensure that the control ring reaches its final installation
position.
•
Tighten tool and new radial seal carrier with internal
hexagon screws F on crankshaft flange.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicité
