LGB 99 Serie Mode D'emploi page 11

6, 5, and 5 and press the right arrow button. The display
shows "P --" again: Input 5, 5, and 5 and press the right
arrow button again.
Controllable Functions
Lighting
Smoke generator on/off
All manuals and user guides at all-guides.com
1
SERVICE
Lubrication
The axle bearings and the side rod ends should be lubrica-
ted occasionally with a small amount of Märklin Oil (7149).
Replacing the light bulbs
Front lanterns: Pull the socket down and out of the lantern.
Remove and replace the bulb. Reassemble.
Rear lanterns: Carefully pry the lens away from the lantern.
Using tweezers, remove and replace the bulb. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the traction tire
• Use a small, straight-blade screwdriver to pry the old
traction tire out of the wheel groove.
• Use a small, straight-blade screwdriver to gently pry the
new traction tire into the wheel groove.
• Make sure that the traction tire is seated properly in the
wheel groove.
Replacing the smoke generator
• Pull the safety cover out of the smoke stack (Fig. 3).
• Use pliers or tweezers to pull the old smoke generator out
of the stack (Fig. 4).
• Cut the wires to the old generator and attach them to the
replacement generator.
• Insulate the connections and push the replacement
generator into the stack (Fig. 5).
• Reassemble.
9