Publicité
Les langues disponibles
Les langues disponibles
Page 4 of 15
Picture 3
Disassembly of OEM Tail Unit:
-
Disconnect the wiring connectors going to the OEM Tail Unit.
-
Remove the 4X OEM bolts circled in Red seen in Picture 1.
-
Remove the OEM Tail Unit and pull through the wiring connectors.
-
Un-screw all visible bolts on the OEM Tail Unit then remove the OEM indicators
for later use.
-
Re-assemble the OEM Tail unit and store away safely.
Tail Tidy Assembly:
-
Attach the OEM indicators to the R&G licence plate bracket (Item 2)
Attach the support bracket (Item 1) to the licence plate bracket using the supplied countersunk
-
bolts (Item 4), washers (Item 6) and Nyloc nuts (Item 7). As shown in Picture 2
-
Then attach the number plate light (Item 9) along with the supplied wiring adapter (Item 10)
Use the supplied heat shrink (Item 12) to cover the number plate light wiring and indicator wiring
-
if required.
-
Thread the indicator cables through indicator wiring covers (Item 13) (these may need to be
trimmed to fit the connectors through) then through the holes in the support bracket.
-
Offer up the tail tidy to the motorcycle and pass the connectors through the hole in the undertray.
-
Then pass the supplied button head bolts (Item 5) with washers (Item 6) through the main
bracket, spacer plate (Item 3) then the motorcycles undertray. (Picture 3)
-
Loosely fit the washers (Item 6) and nyloc nuts (Item 7). (Picture 4)
-
Connect the indicator and number plate light connectors to the original loom.
Test the indicators and number plate light function correctly before tightening the bolts fully.
-
-
Direct the wiring in a favourable position (out of sight and not crushed by anything) using the
supplied cable ties (Item 11) where neccessry.
Then fully tighten the bolts to the required torque spec.
-
IMPORTANT: FOR SAFETY, ENSURE THE LICENCE PLATE IS PLACED AS HIGH AS POSSIBLE ON
THE TAIL TIDY (IT MAY REQUIRE DRILLING). IF FITTING A LICENCE PLATE OF 200MM OR
LONGER (INCLUDING ANY SHROUD OR REFLECTOR ATTACHMENT) TO THE BRACKET, BEFORE
Unit
Tel: +44 (0)
420 89007 Fax: +44 (0)
1
FITTING INSTRUCTIONS
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301 www.rg-racing.com Email: info@rg-racing.com
1
R&G
LP0355
Picture 4
Publicité
