Power Fist 8643926 Mode D'emploi page 16

8643926
2. Place one of the five male quick-disconnect
pressure nozzles into female the quick coupler.
3. Check the position of the pressure nozzle's
opening. This will determine the spray angle
when the spray gun is held in a level position.
4. Press down on the nozzle. The collar will snap forward with a loud click. The
nozzle is locked in place.
5. Pull the high pressure nozzle and spray wand in opposite directions to
ensure they do not separate.
6. Turn off pressure washer and release pressure in the system before
attempting to change pressure nozzles.
PRESSURE NOZZLE SELECTION
The pressure washer has five spray nozzles. Each nozzle is color coded and delivers
a specific spray arc between 0° and 65°. The narrower the degree arc, the higher
the pressure at the water spray's point of contact with the item being cleaned.
Distance from the item that is being sprayed will also factor into the pressure level
at the point of contact.
The table identifies the colour, arc and an example. The purpose example is only a
suggestion as some items are made of multiple materials and not all materials will
withstand the force of the pressurized spray. Choose the nozzle with the largest
spray arc, if you are unsure how much pressure to apply to an item without
damaging it. Switch to a nozzle with a narrower degree angle until you find the one
that achieves the results you want.
The nozzles are stored on the panel mounted on the pressure washer's handle.
Colors on the panel identify the correct nozzle location.
16
All manuals and user guides at all-guides.com
4.2 GPM @ 4,000 PSI Gas Pressure Washer
For technical questions call 1-800-665-8685
V 4.0
Fig. 15