Publicité
Les langues disponibles
Les langues disponibles
8643926
c.
Release the collar and it will snap forward.
Listen for click to ensure both quick-
disconnects are coupled.
2.
Pull the high pressure hose and the spray gun
in opposite directions to ensure they do not
separate.
3.
Connect the spray wand to the spray gun by
threading it into place. Secure hand tight
(Fig. 9).
4.
Connect the water source.
a.
Connect the hose and water supply to
the pump.
b.
Attach the other end of high pressure
hose to the high pressure outlet on the
pump. Pull down the quick connect
collar, slide onto the pump outlet and
release the collar (Fig 10 – 1). Pull on
hose to ensure a tight connection.
c.
Before connecting a garden hose to
pump inlet, inspect the inlet screen
(Fig. 11-1). Clean the screen if it contains
debris or replace it if damaged. DO NOT
run pressure washer if inlet screen is
damaged.
d.
Run water through your garden hose for
30 seconds to clean out any debris.
IMPORTANT! DO NOT siphon standing water
for the water supply. Use only clean, cold
water (less than 100°F).
d.
Connect the garden hose (not to exceed 50 feet in length and with the
ID no less than 13 mm) to the water inlet (Fig. 11-2). Tighten by hand.
12
All manuals and user guides at all-guides.com
4.2 GPM @ 4,000 PSI Gas Pressure Washer
For technical questions call 1-800-665-8685
10-1
11-1
11-2
V 4.0
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Publicité
