Shindaiwa T282 Mode D'emploi page 7

Assembly (continued)
Cutting Attachment Shield
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
NOTE:
It may be necessary to loosen the retain-
ing nut and clamp screw to adjust cutting
attachment shield mounting plate.
2. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws.
3. Tighten the four socket-head cap
screws to secure the cutting attach-
ment shield.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-head
cap screws.
4. Attach the subshield to the cutting
attachment shield by snapping the
hooks into the hook receivers..
CAUTION!
Make sure the subshield is completely
hooked at the hook receiver.
WARNING!
NEVER operate the unit with-
out the cutting attachment shield
installed and tightly secured!
All manuals and user guides at all-guides.com
Socket-Head
Cap Screws
Shim
Clamp Screw
Retaining
Drain
Nut
Screw
Socket-Head
Cap Screws
Shim
Clamp Screw
Retaining
Drain
Nut
Screw
Bracket
Shim
Mounting Plate
Bracket
Shim
Mounting Plate
Cutting Attachment
Shield w/subshield
T282
Outer Tube
Cutting
Attachment Shield
Line Cutter
T282X
Outer Tube
Line Cutter
7