b) Montage sur semoir NG Plus 3 (avant 2006)
- Enlever le couvercle du boîtier et la distribution.
- Démonter une roue de jauge et un disque
- Démonter la descente de graines en plastique noir (axe, puis goupille).
- Monter la nouvelle descente [A] réf. 7079.a (crochet en bas, axe plus goupille
en haut).
- Monter la cellule [B] à l'aide des deux boulons [C].
- Monter la bavette de protection [D] (réf. 6240) sur le couvercle de distribution
à l'aide des vis [E] (HM 5 x 8) sans oublier la tôle [F] (réf. 6241) comme
présenté ci-dessous.
- Remonter le disque, la roue de jauge, la distribution et le couvercle de boîtier.
- S'assurer que le disque et le couvercle ne touchent pas à la descente de la
graine.
b) Mounting on the NG Plus 3 seeder (before 2006)
- Remove the unit's cover and the feed mechanism.
- Remove the depth wheel and the disk.
- Remove the black plastic grain chute (axle, then pin).
- Mount the new grain chute A ref. 7079.a (hook at the bottom, axle plus pin at
the top).
- Mount cell B using the two bolts marked C.
- Mount protection flap D (ref. 6240) on the feed mechanism's cover using the
screws marked E (5 x 8 HM), not forgetting metal plate F (ref. 6241), as shown
below.
- Remount the disk, the depth wheel, the feed mechanism and the unit's cover.
- Check that the disk and the cover are not touching the grain chute.
b) Montage auf eine Sämaschine NG Plus 3 (vor 2006)
- Nehmen Sie den Deckel des Sägehäuses ab.
- Nehmen Sie ein Furchenrad und eine Scheibe ab
- Nehmen Sie den Zulauf aus schwarzem Plastik ab (erst die Achse, dann den
Stift).
- Montieren Sie den neuen Zulauf A Ref. 7079.a (Haken nach unten, Achse
und Stift nach oben).
- Bringen Sie die Zelle B mit den zwei Bolzen C an.
- Montieren Sie, wie es hier unten gezeigt wird, die Schutzplatte D (Ref. 6240)
auf den Deckel des Sägehäuses. Benutzen Sie dazu die Schrauben E (HM 5 x
8) und vergessen Sie das Blech F (Ref. 6241) nicht.
- Bringen Sie die Scheibe, das Furchenrad, das Sägehäuse und dessen Deckel
wieder an.
- Vergewissern Sie sich, dass die Scheibe und der Deckel den Zulauf nicht
berühren.
13