How To Adjust The Basic Parameters Of The Movement - Kinetec Breva Manuel D'utilisation

Beginning
To stop the unit
To select the Inversion/Eversion movement
To select the Extension/Flexion movement
To display the upper or lower limit of the movement
To change the limit if necessary
To validate the new value, press another key
or wait more than 3 seconds.
Or
Or to display pause in extension or flexion limit
To change the pause if necessary
To validate the new value press another key
or wait more than 3 seconds. The display shows the
selected mode
Comments:
• The values shown in the 'Display' column are examples.

How to adjust the basic parameters of the movement?

Keys to press
PL/FLEX
20
Inversion/Evers.
Right :+
EV
Or
10
INV
10
PL/FLEX
20
PL/FLEX
20
Or
PL/FLEX
20
PL/FLEX
Or
20
PL/FLEX
PL/FLEX
PL/FLEX
Timer disable
PL/FLEX
PAUSE DOR
PL/FLEX
PAUSE PL
PL/FLEX
Or
PAUSE PL
PL/FLEX
20
Display
PL/FLEX
Check if the hand control is not locked
STOP 5 0 (See page 5).
Left :-
The display shows the movement selected
RIGHT INV
and then to choose the foot side (+ for right
stop 5 10
or – for left).
LEFT EV
stop 5 10
pl/FLEX
The display shows the movement with the
STOP 5 0 default settings.
pl/FLEX
PL 5 0
The value blinks.
pl/FLEX
Dor 5 0
DOR/FLEX
The new value blinks.
Dor 5 15
DOR/FLEX
SPEED 2
DOR/FLEX
While the value blinks press the (+) or (-)
Load ___ key to change if necessary.
DOR/FLEX
DOR/FLEX
0S
Successive presses on this key selects the
pause at the extension or flexion limit.
DOR/FLEX
0S
DOR/FLEX
The new pause value blinks.
15S
pl/FLEX
The unit is ready to start with the new
stop 5 15 parameters.
Use of the hand control
Remarks
GB
7