Create AIR MIST Mode D'emploi page 7

• Insert the plug to the electrical outlet, and the indicator light will turn on.
• Press "ON/OFF" and the unit will be on standby mode.
• Press "SPEED" button to open the fan function and choose the air flow as Low, Mid, High
speed that matches the light on the control panel.
• Press "OSC" to start oscillation; press again to fix the airflow direction.
• Press "TIMER" button to set the working time of the unit. There are 4 indicator lights for
automatic timing. To set a time of 7.5 hours you need to press 5 times and all the 4 indicator
lights light up.
• Press "MODE" to choose the air flow type from one of the following:
• "Nature": Imitates the flow of natural wind based on strong and soft air flow.
• "Sleep": The fan runs for half an hour on strong then soft natural wind mode, then change
to soft natural wind for the next half hour, and then the fan turns off automatically.
• Setting H with operation pattern: H - Stop - H - Stop - H
• Setting M with operation pattern: M - Stop - M - Stop - M
• Setting L with operation pattern: L - Stop - L - Stop - L
• Press "MIST" to start the mist function. Mist comes out of the front plate if there is water in
the tank. The MIST function can be used on its own or along with the fan function to blow
the mist into the room.
• The Remote Control must be pointed towards the Remote Sensor on the main unit for
best results. If the remote control doesn't operate as expected, replace the batteries (1pc,
CR2025 3V Lithium Cell).
REMOTE CONTROL
1. Power button
2. Speed
3. Mist
4. OSC
5. Timer
6. Mode
• Power button: To switch on and off the device.
• Speed: To set the wind flow as High, Mid or Low.
• Mist: To turn on or off the misting function. It can work without turning the fan on.
• OSC: To turn on or off the oscillation function.
• Timer: To set the working time of the unit.
• Mode: to choose the air flow type as Nature or Sleep.
1
2
3
4
5
6
E NGLISH 7