Training Pet - Petsafe HPA11-10888 Guide D'installation

5D
5E
Step
6

Training Pet

6A
5D Use a screwdriver to evenly tighten screws
throughout frame. After tightening screws, check to make
sure flap swings freely and moves back to the center to
meet magnet on bottom of interior frame. It may be
necessary to adjust screws to make sure frames cover
cut-out and the flap swings freely.
Use a manual screwdriver to tighten screws. Do
not overtighten. Overtightening can warp the pet
door frame.
5E Insert finishing plugs into screw holes in interior
Optional
and exterior frames for a polished look.
Optional:
Caulk inside threshold where frames,
core covers, and tunnel support meet for weather
resistance.
6A Rehang your door and begin training your pet. It may
help for you to be on one side of the door and your pet
on the other. Lift or tape open flap and try to talk your pet
through the pet door. After your pet has gone through a
few times, allow the flap to touch your pet's back so they
will become comfortable using the pet door. If your pet
will not go through the door, tape the flap open until they
use it on their own. Do not use the 4-way lock until your
pet is familiar with using the pet door.
Helpful Tip: Try treats or toys to encourage your pet to go
through the pet door and become comfortable using it.
www.petsafe.net
NOTICE
9