Ribimex ELAGSB Manuel D'instructions Et D'utilisation page 18

• With allowing the chainsaw running, press the bulb pump cap for 3-4 times. See Fig 4b.
4.7- Saw chain tension adjustment (Fig. 5)
• WARNING! Remove battery pack (7) from
the chainsaw before servicing.
• WARNING! Risk of cut. Wear protective
gloves before servicing.
• Chain tension checking
Rest the tool on the firm surface. Gently pull
the chain 1/8" away from the bottom of guide
bar (12) and release. If the chain return to
original position, the tension is correct. If a
slight sag (1/16" or less) is observed, it is
acceptable. Otherwise, adjust the chain tension.
• Chain tension adjustment
Turn the chain tension adjustment knob clockwise to tighten the chain. Turn the chain tension
adjustment knob anti-clockwise to loosen the chain.
4.8- Switch On/Off
• To start cutting, press and hold the trigger lock (3) and power trigger (9) together, then the
chainsaw starts to run.
• To stop the chainsaw, release both trigger lock (3) and power trigger (9).
4.9- Using with Ribimex telescopic pole (PRBAT20/EST, not included)
Ribimex telescopic pole (PRBAT20/EST) should be purchased separately.
Attaching the mini chainsaw to the telescopic pole (Fig. 6)
• Make sure both battery pack (7) and battery adaptor (5) are removed from the chainsaw (refer
to Section 4.4 and 4.5).
• Slide the tool into the telescopic pole slot until the tool is locked into position and a "click"
sound is heard.
• Always secure the connection with fastening the latch toggle clamp.
Fig. 4a Fig. 4b
Fig. 5
Page 18 / 36