IKEA TYNNERAS Mode D'emploi page 6

ENGLISH
Damaged gaskets must be replaced as
soon as possible.
Use the freezer compartment only for
storing frozen food, freezing fresh food
and making ice cubes.
Avoid storing unwrapped food in
direct contact with internal surfaces of the
freezer compartments.
C-Pentane is used as blowing agent in
the insulation foam and it is a
The most appropriate compartments
food are to be stored, taking into account
are as follows:
- Freezer compartment:
4 star zone (****) compartment is suitable
temperature and for storing frozen food
as the temperature is evenly distributed
throughout the entire compartment.
Purchased frozen food has the storage
expiration date stated on the packaging.
This date takes into account the type of
food being stored and therefore this date
should be respected.
To avoid food contamination, please
observe the following:
– Opening the door for long periods
temperature in the compartments of the
appliance.
– Regularly clean surfaces that may come
into contact with food and accessible
drainage systems.
– Clean water tanks if they have not been
connected to a water supply if water has
not been drawn for 5 days.
containers in the refrigerator, so that it
does not come into contact with or drip
onto other food.
– If the refrigerating appliance is left empty
dry, and leave the door open to prevent
mould developing inside the appliance.
INSTALLATION
The appliance must be handled and
installed by two or more persons - risk of
injury. Use protective gloves to unpack and
install - risk of cuts.
Installation, including water supply (if
any), electrical connections and repairs
technician. Do not repair or replace any
stated in the user manual. Keep children
away from the installation site. After
unpacking the appliance, make sure that it
has not been damaged during transport.
In the event of problems, contact the
dealer or your nearest Aftersales Service.
Once installed, packaging waste (plastic,
styrofoam parts etc.) must be stored out
The appliance must be disconnected from
the power supply before any installation
operation - risk of electric shock.
During installation, make sure the
appliance does not damage the power
Only activate the appliance when the
installation has been completed.
(e.g. parquet) when moving the appliance.
strong enough to take its weight and in a
place suitable for its size and use. Make
sure the appliance is not near a heat
source and that the four feet are stable
as required, and check that the appliance
is perfectly level using a spirit level. Wait
at least two hours before switching
the appliance on, to ensure that the
To guarantee adequate ventilation,
leave a space on both sides and above
the appliance. The distance between
the rear of the appliance and the wall
behind the appliance should be 50 mm, to
avoid access to hot surfaces. A reduction
of this space will increase the Energy
consumption of product.
WARNING: When positioning the
appliance, ensure the supply cord is not
trapped or damaged.
WARNING: To avoid a hazard due to
appliance must be done in accordance
with the manufacturer instructions. It's
forbidden to place the freezer in such way
that the metal hose of gas stove, metal
gas or water pipes, or electrical wires
are in contact with the freezer back wall
(condenser coil).