Description Of The Status Leds; Description Of The Reset Button Function - Abus TVIP62500 Manuel Utilisateur

3.5 Description of the status LEDs

State
Off
On
Flashes max. 3 times

3.6 Description of the reset button function

Restoring the factory settings
a) Remove the power supply unit from the camera.
b) Press the reset button.
c) Reattach the power supply unit whilst holding down the reset button, then keep it held down
for 10 seconds.
Restarting
a) The camera is restarted if the reset button is pressed once briefly.
Description
IP address allocation
IP address allocation successful
Communication with IR LED circuit
board/photo sensor established
49