Powersmart DB2317 Mode D'emploi page 99

•
Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on any
part of the power tool.
•
Read, understand, and follow the instructions.
OPERATING INSTRUCTIONS
WARNING: Read and thoroughly understand all instructions and safety information before
operating this string trimmer. Failure to do so may cause serious injury or death. Do not allow
anyone to operate this string trimmer who has not read this manual. A string trimmer can be
dangerous if assembled or used improperly. Do not operate this string trimmer if you have doubts or questions
concerning safe operation. Call our customer service department at 1-800-791-9458 to address these
concerns.
STARTING/STOPPING THE STRING TRIMMER
Install the battery pack. (Refer to Installing the battery pack)

To start the string trimmer, press the self-locking button (1) first, then press

the trigger switch (2).
There are two speeds. Speed 1: tap the trigger switch; Speed 2:

continuously press the trigger switch twice.
To switch off, release the trigger switch (2).

WARNING:
The tool runs for approximately 3 seconds after it has been switched off. Let the motor come to a
complete standstill before setting the tool down.
CUTTING BLADE ADJUSTMENT
The cutting blade can be rotated 180 ° to change the cutting width from 12 inches to 13 inches.
EDGING FUNCTION
For use next to patios, driveways and walkways or any areas requiring a well groomed edge line.
Push on the edge button(1) and tilt the trimmer head 90 degrees until the head locks into position and release
button.
IMPORTANT: The battery must be removed before making adjustments.
15