Powersmart DB2317 Mode D'emploi page 97

INSTALLING THE SAFETY GUARD
To avoid injury, always remove the battery pack before installing the guard, changing a cutting line, or
making any adjustments.
If the guard is damaged, do not use the grass trimmer/edger until it is replaced.
NOTE: Install the protective guard before operating the grass trimmer/edger. It cannot be removed or
disassembled.
1. Remove the battery pack.
2. Invert the grass trimmer/edger to access the trimmer head.
3. Insert the safety guard into the corresponding slot on the housing in
the direction of the arrow. Lock with screws.
INSTALLING THE AUXILIARY HANDLE
WARNING:To avoid injury, adjust the auxiliary handle for optimum control and balance. Do
not overreach when operating string trimmer/edger. Keep proper balance at all times for better
control of the tool in unexpected situations.
1. Install M5 lock nut nut into the locking block.
2. Align the convex point on the locking block with the hole in the pipe and install it
3. Cover the auxiliary handle.
4. Lock with 4pcs bolts (M5*30).
CONNECTING THE UPPER SHAFT AND THE TELESCOPIC SHAFT
Align the arrow on the upper handle (1) with the convex point (2) on the telescopic shaft and insert it to the
1.
end.
2. Hold the upper handle and tighten the telescopic shaft.
13