GEMÜ 566 eSyStep Notice D'utilisation page 25

12.2 Données de processus
L'actionneur linéaire à commande motorisée dispose de données de processus IO-Link. Celles-ci sont transmises de manière
cyclique en même temps que chaque télégramme IO-Link.
Master → Device
Name
Drive go Open
Drive go Close
Start initialization
Locate
Setpoint analog
Device → Master
Name
Valve position Open
Valve position Close
Operating mode
Valve position analog
www.gemu-group.com
Bit
0 0 → Actuator does not move into position Open
1 → Actuator moves into position Open
1 0 → Actuator does not move into position Closed
1 → Actuator moves into position Closed
2 0 → No initialization
1 → Start initialization
3 0 → Off
1 → On
8 ... 23 Setpoint in the range 0 ... 1000
Bit
0 0 → Process valve not in Open position
1 → Process valve in Open position
1 0 → Process valve not in Closed position
1 → Process valve in Closed position
2 0 → Normal operation
1 → Initialization mode
8 ... 23 Position of the valve in the range 0 ... 1000
25 / 61
12 Données spécifiques IO-Link (broche 6)
Values
Values
GEMÜ 566 eSyStep
Code S0