Canon K10297 Guide D'utilisation page 43

7
Hang up the Handset and press [Stop].
The fax returns to standby mode.
Note
You cannot delete the <OUTGOING MESSAGE>. To record a new outgoing message, repeat
steps 1 to 7. The old outgoing message will be automatically deleted when you record your new
message.
Setting TAM MODE
Setting TAM MODE allows you to receive telephone messages (ICM) and fax transmissions while
the fax is unattended. When you cancel TAM MODE, any new telephone messages will be played
automatically.
1
Press [TAM] to set TAM MODE.
15:00
When you set TAM MODE, the TAM Lamp lights up and the outgoing message is played.
When you cancel TAM MODE, the TAM Lamp switches off. If you have any new telephone
messages, the messages are played automatically.
To cancel TAM MODE, press [TAM] again.
Note
<NO OGM> is displayed on the LCD when no outgoing message has been recorded. You must
record an outgoing message before you can set TAM MODE (see page 38).
A maximum of 55 messages, including an outgoing message, alternative message, voice
memos, Fax/Tel message and forwarding message, with a total maximum recording time of 30
minutes can be recorded. You can set a maximum recording time of 240 seconds for each
telephone message (see page 40).
The number of messages or total recording time may be reduced if there are many faxes stored
in memory.
If you have any new telephone messages, the TAM Lamp blinks and the number of messages
appears on the LCD.
The day and time when the telephone message was recorded, the number of telephone
messages and the number of the message being played (ICM No.) are displayed whenever a
message is played.
Note
When the fax is set to <MANUAL MODE> and <MAN/AUTO SWITCH> has been set to <OFF>
(see page 51), TAM MODE will be activated if the fax rings 15 times and the call is not answered
(only when an outgoing message has been recorded). When the call is disconnected, the fax
returns to <MANUAL MODE>.
Setting the Recording Time for a Telephone Message
1
Press [Menu].
2
Use [ ] or [ ] to select <DATA REGSTRATION>, then press [Start]. The LCD
displays <USER SETTINGS>.
:00
Using TAM Mode (FAX-JX500/JX300 only) 39