Publicité
Les langues disponibles
Les langues disponibles
2
appliance description
1. Lid with sealing ring
2. Handle
3. Controllights (blue/red)
4. Start button for heating and frothing
5. Base
6. Maximum indication for heating milk - MAX
7. Maximum indication for frothing milk - MAX
8. Whisk (frothing)
9. Mixer (heating)
3
before first use
Before you use the appliance for the first time, please do
as follows: Carefully unpack the appliance and remove all
the packaging material. Keep the material (plastic bags and
cardboard) out of reach of children. Check the appliance after
unpacking for any visible damage, possible from transportation.
Place the appliance on a stable and heat resistant surface.
Clean the lid, the whisk and the mixer with warm soapy
water. Dry the parts thoroughly. Make sure that the parts are
completely dry.
Wipe the exterior and interior with a soft damp cloth and dry
thoroughly. The appliance is only suitable heating and frothing
milk. Never fill the appliance with other drinks.
4
preparing milk foam
Check that the voltage in your home corresponds with the
voltage printed on the bottom of the appliance and plug
the appliance in.
Lift the lid and fit the whisk in the jug. Fill the desired amount of
milk into the jug. Do not exceed the maximum of the lower max.
mark - MAX
- 115 ml. Frothed milk expands and causes the
pitcher to overflow, if filled up too high. The minimum capacity
is 50 ml.
Put the lid back on the jug and place the appliance on the base.
Start the preparation by pushing the button. The control lights
(blue/red) will burn and the whisk will start turning. Depending on
the filling volume, the preparation stops automatically after ca.
90 seconds. The blue control light goes out and the red light will
blink for about 30 seconds to indicate the milk frother is ready.
10
•
English
6
7
8
9
After the preparation is completed, remove the lid upwards and
pour or ladle the milk foam into a cup or bowl. Do not remove
the foam with a spoon or other metal object. This will damage
the coating.
After having used the frother, clean the appliance as described
in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 minutes before using it
again or rinse it with cold water. The milk frother will be faster
ready to use it again.
TIPPS
• The best result is achievement when using whole milk.
• If the amount of milk of too low the result will not be good -
less than 50 ml.
5
heating milk
Lift the lid and fit the mixer in the jug. Fill the desired amount of
milk into the jug. Do not exceed the maximum of the top max.
mark - MAX
- 240 ml.
Put the lid back on the jug and place the appliance on the
base. Start the preparation by pushing the start button. The
control lights (blue/red) will burn and the mixer will start
turning. Depending on the filling volume, the preparation stops
automatically after 100 to 120 seconds. The blue control light
goes out and the red light will blink for about 30 seconds to
indicate the milk frother is ready.
After the preparation is completed, remove the lid upwards and
pour the hot milk into a cup. After having used the appliance,
clean it as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 minutes before using it
again or rinse it with cold water. The milk frother will be faster
ready to use it again.
1
2
3
4
5
Publicité
