hestan KRT Serie Manuel D'utilisation Et D'entretien page 19

CARE & MAINTENANCE
SEALED BURNERS
BURN HAZARD - To prevent burns, do not touch the burner heads or cooking grates when hot.
Allow to cool completely.
The burners can be disassembled for cleaning. Use only a small toothbrush to clean the burner ports
and igniter. DO NOT insert sharp objects or scratch the burner ports. After cleaning, ensure the
sealed burner heads are properly installed and seated on the burner base as shown below. There are
notches on the burner base and cross ring to help with alignment. The outer burner head features a
long slot on the top of the head which aligns with the spark igniter. Assembly of the single-flow
burner head is similar.
INNER
BURNER
HEAD
OUTER
BURNER
HEAD
BEAUTY
RING
DUAL FLOW BURNER
SUGGESTED CLEANERS:
BRASS BURNER / HEADS
Hot water & mild detergent
Bon-Ami ®
Kleen King
®
CERAMIC IGNITER
Hot water & mild detergent
Fantastik ®
CAST IRON COOKING GRATES WITH PORCELAIN ENAMEL
Hot water & mild detergent
Bon-Ami ®
Kleen King ®
SoftScrub ®
Use care when handling the grates. They are heavy and can crack if dropped on the floor or hard
surface. DO NOT clean the grates in a self-cleaning oven. Do not allow food stains or acidic food
spills to remain on the grate surfaces too long. These stains can degrade the enamel. For stubborn
stains, use light pressure with an abrasive cleaner. Rinse thoroughly and dry immediately.
CROSS
RING
BURNER
BASE
SINGLE FLOW BURNER
©2019 Hestan Commercial Corporation
BURNER
RING
BURNER
HEAD
BURNER
BASE
IGNITER
17
EN